Adding a removing Z-Wave devices #85

New Issue

Closed

opened 2022-07-05 01:38:48 +02:00 by blacklight · 0 comments

blacklight commented

2022-07-05 01:38:48 +02:00

Owner

Created by: WojtekKozaczynski

I am using GE Z-Wave smart switch and Z-Wave.Me USB Smart Home Stick, which work fine in Home Assistant (HA). I noticed two issues

I attempted to add the switch (again) - I missed that probably because the switch and USB controller have been paired already in HA they both showed up as know devices in platypush. That put the controller in the synch mode that did not stop. Even when I restarted platypush it went back in the synch mode again. I had to reboot the Pi.
When I tried to remove the switch (log enclosed) platypsh did not remove it and went into an unstable mode (from log messages it looks like it was looping).
2_platypush.log

*Created by: WojtekKozaczynski* I am using GE Z-Wave smart switch and Z-Wave.Me USB Smart Home Stick, which work fine in Home Assistant (HA). I noticed two issues 1. I attempted to add the switch (again) - I missed that probably because the switch and USB controller have been paired already in HA they both showed up as know devices in platypush. That put the controller in the synch mode that did not stop. Even when I restarted platypush it went back in the synch mode again. I had to reboot the Pi. 2. When I tried to remove the switch (log enclosed) platypsh did not remove it and went into an unstable mode (from log messages it looks like it was looping). [2_platypush.log](https://github.com/BlackLight/platypush/files/4660799/2_platypush.log)